Before we install the flywheel, we'll put a little bit unusual of Loctite on each of the new flywheel bolts, put the new flywheel up into place. Now we'll install our new ARP bolts. Now we'll get our flywheel bolts a little tight 2017 unusual interior separator before we torque them down. Now we'll install two of the new metric screws for our clutch. Now we can use a pry bar to hold our engine in place while we torque our flywheel bolts down.
M-6375-A302B Mustang Ford Racing Modern brick home design
[Now what you want to do is get a pry bar. We ll put it between the two bolts. We.
[Now we torqued them all to 75 foot pound. We re going to go in a crossing pattern. Now we.
[Before we cut our H pipe, we re going to remove this fork plate. This is only going to be.
[We don t need to tighten it all the way, just give it one or two turns. To remove our.
[Then we re going to work on the bolts for the crossmember. These are usually the most rusted bolts in.
[We ll leave that in there for now, and torque down the bolts. We re going to start by torquing.
[Now we re going to disconnect our H pipe at our headers. We ll leave the top bolt in just.
[Before we install the flywheel, we ll put a little bit of Loctite on each of the new flywheel bolts.
[Headers are going to make it a little bit harder, but you got to get it off though. We re.
[So today, we re going to give the 67 two more forward gears by doing a T5 conversion using parts.
[There you can see the difference between your original bushing and the new bearing we re going to have to.
[Okay, I never thought that would be that easy. The six bell housing bolts that you removed, there s going.
[Now we have everything apart, we re going to clean up a little bit in here, and we re ready.
[We ve got our transmission in place to hold our 3-speed. Any kind of a jack will work, you just.
[Now we re just going to disconnect the spring. Now we can start on removing the transmission from the bell.